Page 1 of 1
Fiberglass bolts
Posted: Mon Jun 01, 2015 9:51 am
by carojae
Anyone have a affordable source for buying limited quantities for these bolts and nuts (5/6"x2", 3/8" x 2") ?
Thank,
Jim
Re: Fiberglass bolts
Posted: Sat Jun 20, 2015 7:26 am
by Breadline
I had trouble finding fiberglass bolts in reasonable quantities and finally ended up buying 3/8" x 48" threaded rod with the corresponding flanged nuts from eplastics.com
Re: Fiberglass bolts
Posted: Sun Jul 05, 2015 1:57 pm
by Lulu
McMaster-Carr Google their web site. Then type "fiberglass fasteners" in their search window. They have it all including flanged nuts (you wouldn't need washers and the nut is deeper than standard nuts giving you more holding surface)
Re: Fiberglass bolts
Posted: Sat Jul 11, 2015 1:14 pm
by carojae
Thank you for the reply Lulu.
Great site and it's just what was wanting with quantities I can afford.
Jim
Re: Fiberglass bolts
Posted: Wed Aug 19, 2015 8:36 pm
by Scotthmt
I used pvc and hooked a whale, almost lost my Gurdy but was able to cut the wire in time
Re: Fiberglass bolts
Posted: Sat Aug 22, 2015 10:28 am
by John Murray
now that's what I call a testimonial,thanks I'm changing mine.We luck out while anchoring in Malisbury in late July,a whale chasing feed came between the boat and stabi line it got caught in stabi haul back line broke that, lucky it wasn't caught in stabi line.
Re: Fiberglass bolts
Posted: Wed Aug 26, 2015 7:28 am
by Scotthmt
Just installed fiberglass bolts, they don't take well to over torquing, seems they have no stretch at all, tighten too much and they snap. I think in the offseason I will remount with steel bolts and fiberglass washers and insulating tubes.
Re: Fiberglass bolts
Posted: Tue Oct 20, 2015 11:38 am
by Lulu
Correct, you can not over torque fiberglass like SS. However, there is no concern of stray current passing through or along fiberglass as one will have with metal bolts
I've used fiberglass for years. Caught three wires on a reef, being to aggressive fishing a pile of bait, pulled the davit, literally to the deck, bent the gurdie's shaft, and the bolts held without budging. Can't do that with nylon. Metal bolts defeat any efforts to isolate the gurdies. In my opinion, fiberglass is the best choice and a lot less expensive compared to SS