Rebuilding hold

Discussion related to commercial salmon trolling, boats, gear, fishing techniques, electronics, marketing, etc.
Post Reply
Hans2
Site Supporter
Site Supporter
Posts: 88
Joined: Wed Apr 21, 2010 2:10 pm
Spammer?: No

Rebuilding hold

Post by Hans2 »

Wintertime project creep has set in big time... leading me to ask how you all suggest I finish off my hold interior with? I found some wet insulation while I was doing an ergonomics improvement project, leading to a hold reconfigure, leading to me having a hold with bare owens corning foam board walls... so, what is the best way to finish it off? Let's just say I'd prefer not to redo it the way the builder did it... looking for the current best practices. It is an ice hold with a Nomar slush tank liner. Looking at an epoxy finish over a 3mm luann ply surface, but open to ideas.
Thanks -
MonkeyFish
Member
Posts: 6
Joined: Mon Feb 04, 2013 7:44 pm
Spammer?: No
Location: Oregon/Washington.

Re: Rebuilding hold

Post by MonkeyFish »

I just sent ya a pm. Good fishin'
Post Reply